Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
facilities:irradiation:bern_medical_cyclotron [02:15 25/05/2022] – [References] jhulsmanfacilities:irradiation:bern_medical_cyclotron [17:28 25/05/2022] (current) – [Facility] jhulsman
Line 22: Line 22:
 The protons are directed into a separate bunker (as depicted in the figure below) via a beam transfer line. It is 6.5m long and consists of 1 dipole doublet for horizontal/vertical steering and 2 quadrupole doublets for focusing. An additional neutron shutter (to stop the neutron flux) is included. 2 beam viewers provide a destructive beam current measurement. The protons are directed into a separate bunker (as depicted in the figure below) via a beam transfer line. It is 6.5m long and consists of 1 dipole doublet for horizontal/vertical steering and 2 quadrupole doublets for focusing. An additional neutron shutter (to stop the neutron flux) is included. 2 beam viewers provide a destructive beam current measurement.
  
-{{ :facilities:irradiation:bern_medical_cyclotron:bern_proton_btl.png?direct&600 | Beam Transfer Line schematic}} +{{ :facilities:irradiation:bern_medical_cyclotron:closedcyclotron.jpg?nolink&600|Beam Transfer Line photo}} 
-{{ :facilities:irradiation:bern_medical_cyclotron:closedcyclotron.jpg?direct&600 |Beam Transfer Line photo}}+{{:facilities:irradiation:bern_medical_cyclotron:bern_proton_btl.png?nolink&600|Beam Transfer Line schematic}}
  
 Collimators allow for proton beams to have an area of $1cm^2 \times 1 cm^2$ to $3cm^2 \times 3 cm^2$. Setups can be placed in front of the collimator on a motorized linear actuator. Setups can be irradiated in "passive mode". However, it is also possible to take data during the irradiation  via a patch panel (connected to the physics laboratory). Collimators allow for proton beams to have an area of $1cm^2 \times 1 cm^2$ to $3cm^2 \times 3 cm^2$. Setups can be placed in front of the collimator on a motorized linear actuator. Setups can be irradiated in "passive mode". However, it is also possible to take data during the irradiation  via a patch panel (connected to the physics laboratory).